■ 8 │ GB│IE
SED 400 A1
Initial operation
Before starting to use the appliance, ensure that…
– the appliance, power plug and mains cable
are in perfect condition
and…
– all packaging materials have been removed from the appliance.
1) Clean all parts of the appliance as described in the section entitled "Cleaning
and care".
2) Unwind the mains cable
from around the cable retainer and guide it
through the recess on the edge.
3) Insert the plug into a suitable mains power socket.
The appliance is now ready for use.
Cable retainer
There is a cable retainer on the base of the appliance. This retainer allows
you to adjust the length of the cable to your requirements.
CAUTION – PROPERTY DAMAGE!
► Ensure that you always guide the mains cable
through the correspond-
ing gap in the rear of the appliance base for the sake of stability.
NOTE
► Always wrap the power cable
around the cable retainer in a clock-
wise direction. This reduces the length of the cable to a minimum, allowing
you to guide the mains cable
through the gap in the appliance base
.
Preparing eggs
1) Pick a hole in the bottom of the egg with the egg pick . This allows the air
inside the egg to dissipate as it expands during boiling. It prevents the shell
from bursting open. The hole you pierced previously should point upwards
when you place the eggs in the cooking insert .
2) Place up to 7 eggs on the cooking insert
with the picked side up.
3) Fill the measuring cup
up to the MAX marking with tap water and tip this
water into the cooking bowl .
4) Place the cooking insert
into the cooking bowl and place the lid on top.
IB_352644_SED400A1_LB8.indb 8 04.01.2021 10:32:36
To Next Page
Loading...
