19 GB/IE/NI/CY
Cleaning the filters
and dust collector
Clean the filters (HEPA filter
25
and stainless steel filter
27
) after
every two or three uses. Other-
wise the vacuum function will be
reduced and the product could
be damaged.
Do not wash the filters (HEPA
filter
25
and stainless steel filter
27
) in the dishwasher or wash-
ing machine.
Do not clean the HEPA filter
25
under running water.
Do not clean the dust collector
21
in the dishwasher.
Allow the stainless steel filter
27
to air dry thoroughly after clean-
ing.
Do not put the stainless steel
filter
27
in the dryer or on the
stove to dry.
IMPORTANT: Allow all parts
of the product to dry thoroughly
after cleaning. If the stainless
steel filter
27
is not fully dry, wa-
ter may seep into the product
and damage it!
To clean the filters, follow these steps:
Switch the product off using the On / Off
button
19
(see Fig. A).
Remove the aluminium suction tube
16
from
the main unit
4
by pushing the upper release
button
20
and removing the aluminium suction
tube
16
from the main unit
4
.
Remove the dust collector
21
from the main
unit by pushing the release button
22
on the
base of the dust collector
21
and carefully
removing the dust collector
21
(see Fig. H).
Ensure that the dust collector
21
is empty (see
chapter “Emptying the dust collector”). Tap the
dust collector
21
out again over a waste bin if
needed.
Remove the cover
24
of the dust collector
21
by turning it to the right until the marking on the
cover
24
is above the - symbol. Remove the
cover
24
, pulling it upwards.
24
Take the entire filter unit out of the dust collec-
tor
21
.
Remove the HEPA filter
25
from the filter carrier
26
by pulling it out upwards on the flap.
To Next Page
Loading...
