13
SIKP 3400 A1
GB
5) To switch the cooking area 1 off , press the button “On / Standby” w.
To switch all cooking areas 1 2 4 off at the same time, press the button
“On / Standby” t
.
NOTICE
► When all 3 cooking areas 1 2 4 are off , after usage or adjustment,
you must fi
rst press the button "On / Standby" t to carry out new settings.
NOTICE
► After switching on or off , an "- L" or a "- H -." appears in the display.
This heat indicator means:
–"- L -" = "Low" - Temperature of the cooking areas 1 2 4 < 60°C
or
–"- H -" = "High" - Temperature the cooking areas 1 2 4 > 60°C
NOTICE
► After switching off , in the standby mode the fans of the appliance continue
to run on for some time, so as to dissipate the heat.
NOTICE
► The appliance switches itself into the standby mode automatically after
120 minutes.
Safety switch off
■ For safety reasons, the cookware identifi cation automatically switches the
appliance off (in standby mode) when you ...
– remove the cookware from the cooking areas 1 2 4 for longer than
15 seconds, or do not place anything there..
– Although the energy fi eld is immediately switched off with short-term
cookware removals - the selected function remains, however, active.
Around every 3 seconds a signal tone issues a reminder that, in roughly
15 seconds, the appliance will switch itself off automatically. If you
replace the cookware back onto the cooking areas 1 2 4 within
15 seconds, the selected function will continue on the same settings.
NOTICE
► As soon as you take the cookware from the cooking area, "- - -" blinks in the
display.
To Next Page
Loading...
