Why my Silvercrest Hob does not start cooking?
If the Silvercrest Hob is not starting, it could be due to several reasons: * There is no cooking vessel on the induction field. Place a suitable pot or pan on the induction field. * The pot or pan is not suitable for induction cookers. Use a suitable pot. * The child lock is activated. Deactivate it by holding down the r and z buttons for about 3 seconds.
What to do if Silvercrest SDI 2800 D4 Hob displays error code "(19"?
If the Silvercrest Hob displays "(19", it indicates that the electronics have overheated. Ensure that the fans on the bottom of the appliance are functioning correctly and can draw in enough air.
What does "(16" mean on Silvercrest SDI 2800 D4 Hob?
If the Silvercrest Hob displays "(16", it means the appliance is receiving excessively high voltage (greater than 275 V). Ensure it is connected to a properly installed mains power socket supplying 220–240 V ~, 50/60 Hz.
What does "(17" mean on Silvercrest SDI 2800 D4 display?
If the Silvercrest Hob displays "(17", it indicates that the appliance is not getting enough voltage (less than 150 V). Ensure the hob is connected to a properly installed mains power socket that supplies 220–240 V ~, 50/60 Hz.
What to do if Silvercrest SDI 2800 D4 Hob displays "("?
If the Silvercrest Hob displays "(", it could mean that there is no vessel on the induction field or the pot/pan is too small. Place a suitable pot/pan on the induction field.
What does error "(15" on my Silvercrest SDI 2800 D4 mean?
If the Silvercrest Hob displays "(15", it indicates that the temperature sensor underneath the induction field is defective. Disconnect the plug from the mains power socket and contact the Customer Service department. Enter the error code.
What does "(18" mean on the Silvercrest SDI 2800 D4 Hob display?
If the Silvercrest Hob displays "(18", this means that the temperature sensor beneath the induction field is defective or there is a short circuit. Disconnect the plug from the mains power socket and contact the Customer Service department. Enter the error code.
General| Brand | Silvercrest |
|---|---|
| Model | SDI 2800 D4 |
| Category | Hob |
| Type | Induction |
| Number of Cooking Zones | 4 |
| Timer | Yes |
| Child Lock | Yes |
| Residual Heat Indicator | Yes |
| Auto Shut-off | Yes |
| Dimensions (W x D) | 590 x 520 mm |
| Cut-out Dimensions (W x D) | 560 x 490 mm |
| Installation | Built-in |
| Voltage | 220-240 V |
| Frequency | 50/60 Hz |
| Features | Pan detection |
To Next Page