Silvercrest SDI 2800 D4 - Automatic Programmes

SDI 2800 D4
GB
│
IE
│
NI
│
CY
│
13 ■
Automatic programmes
Boost
Use the "Boost" programme to speed up the cooking process.
1) Press the "Boost" button
i while cooking.
9 The appliance will switch to the highest output level for around 30sec-
onds. The display t shows the maximum power level for the active
induction field 1/3. The Boost control lamp
a lights up.
2) To cancel the programme prematurely, press the "Boost" button
i again.
Otherwise, the appliance will automatically revert to the previous power or tem-
perature level after 30 seconds. The Boost control lamp a will switch off.
Milk
Use the "Milk" programme to heat milk without it boiling over. The milk is heated
to around 60°C at a low power level and kept at that temperature for around
20 minutes.
1) Press the "Milk" button
u during operation.
9 The Milk control lamp
s lights up. The display t now alternates between
 and the remaining time until the end of the programme, starting at .
NOTE
► You can activate the "Boost" programme at the same time. The "Milk" pro-
gramme is stopped for about 30 seconds and then resumed afterwards.
► If you activate the "Keep warm" programme at the same time, the "Milk"
programme will be cancelled.
2) Press the Mode button
e to stop the "Milk" programme and return to
normal operation.
Keep warm
The "Keep warm" programme keeps the content of the pan at around 60°C for
2 hours. The appliance will switch off the respective induction field 1/3 as
soon as it reaches 60°C. If the temperature falls below 60°C, the appliance
will heat up again.
1) Press the Keep warm button
w during operation.
9 The displayt now alternates between the temperature  and the remain-
ing time until the end of the programme, starting at . The Keep warm
control lamp
9 lights up.
IB_374031_SDI2800D4_IE_NI_CY.indb 13 22.09.2021 14:08:15