43 GB/IE
of the opening and allow the
water to drain (see fig. I).
Connect a suitable drainage h
ose
(not included) to the opening.
Place the open end of the drain
h
ose in a suitable collecting vesse
l
or drain.
Make sure that the drain hose
leads to the drain as directly
as possible and without kinks
or knots. This way, the water
collected during the dehumidifi-
cation process is automatically
fed into the drain.
Troubleshooting
Some errors are caused by minor
malfunctions and can sometimes be
corrected by the user. If you are still
unable to remedy the problem, con-
tact customer service. Do not repair
the product yourself under any cir-
cumstances.
Problem Possible cause Solution
The product
won't start.
The water tank is full. Empty the water tank.
The room temperature is
lower than the set tempera-
ture (cooling mode).
Adjust the temperature
setting.
The product
is not cooling
sufficiently.
Doors and windows are
not closed properly.
Close doors and windows.
There are heat sources in
the room.
Remove all heat sources
if possible.
The hot air outlet hose
13
is
not connected or blocked.
Connect the hot air outlet
hose
13
or clean it.
The temperature setting is
too high.
Adjust the temperature
setting.
The air inlets
5
,
9
are
blocked.
Clean the air inlets
5
,
9
.
To Next Page
Loading...
