GB12
Assembly
Note: Remove all packaging materials from the product.
Note: You will need a screwdriver and a drill to assemble the doorbell.
Note: Only use the screws and dowels supplied for the assembly of
the product.
Mount the receiver (see Fig. E)
Mount the transmitter (see Fig. F)
Preparing for use
Inserting / replacing the batteries
Insert the batteries to provide power to the product before
preparing it for use.
CAUTION! Use the above-indicated battery types only. Failure to
observe this advice may result in damage to the product.
Receiver:
Remove the battery compartment cover
8
from the back of the
product.
Remove the used batteries, if present.
Insert 2 batteries (1.5 V
(direct current)
, type AA).
Note: Ensure correct polarity. This is indicated in the battery
compartment
9
.
To Next Page
Loading...
Need help?
General
