GB14
The transmitter indicates the transmission of the signal to the receiver by
the signal indicator
10
flashing briefly.
Setting the signal type
The receiver can indicate the reception of a door signal either acoustically
or optically or both optically and acoustically.
Using the signal type selector sliding switch
5
, select whether
the signal is to be indicated acoustically or optically or both optically
and acoustically.
Setting the volume
Press the volume button (VOL)
3
until the desired volume is reached.
There are a total of 5 possible volume settings: very loud, loud, medi-
um, soft, very soft.
Selecting the chime
Note: The doorbell has 36 different chimes.
Press the melody selection button
4
. The first audible signal sounds.
Press the melody selection button
4
again to move on to the
next audible signal.
To Next Page
Loading...
Need help?
General
