Silvercrest KH 2396 - The settings menu; Setting the time; Setting the date; Setting the display brightness

- 8 -
Providing mains power
Insert the plug into a mains power socket. The display • r
is illuminated, the time begins to run but the radio is
switched o (Automatic mode).
The settings menu
Setting the time
The radio must be o to set the time.
1. In automatic mode press the button BASS/MODE g
once. The time blinks.
2.
Press the buttons UP/DOWN u/y, to set the time of
day in minute intervals. Press and hold the keys to change
the time in quick succession.
3. Press the button MODE/BASS g again to save the time
of day and move to the date settings.
If, during the settings, you do not press a button within 15
seconds the device saves the setting and returns to the auto-
matic mode.
Setting the date
1. In automatic mode press the button MODE/BASS g twice.
In the display r appears “01.01.10“ and the date indicator
blinks.
2.
Press the buttons UP/DOWN u/y, to set the date
in daily intervals. Press and hold the keys to change the
date in quick succession.
3. Press the button MODE/BASS g again to save the date
and to move to the display brightness setting.
Setting the display brightness
1. In automatic mode press the button MODE/BASS g
three times. In the display r appears “L“ (low) and
shows the lowest of the two brightness levels.
2. Press the button UP h to switch to the brighter illumination
level “H” (high). Press the button DOWN y to switch
back to the lower brightness level.
3. Press the button MODE/BASS g again to save the dis-
play brightness setting and to move to the remind function
settings.
Setting the remind function
You can programme a date, which the device will remind
you of when it arrives.
1. In automatic mode press the button MODE/BASS g four
times. The display r shows, alternatively, a date and the
SDA indicator for the remind date.