Silvercrest KH 2396 - Setting alarm times (Alarms 1 and 2)

- 11 -
Setting alarm times (Alarms 1 and 2)
You can programme two alarm times into your kitchen radio.
Alarm function
Symbol in the display r
Acoustic signal
Radio
Switched o no symbol
1. In automatic mode, press the button VOL. —/ALARM SET
1 h (or VOL. +/ALARM SET 2 j). In the display r the
last set alarm time and the symbol for the type of alarm
are shown.
2. Press the buttons UP/DOWN u/y to set the de-
sired alarm time.
3. Press the button VOL. —/ALARM SET 1 h (or VOL. +/
ALARM SET 2 j) repeatedly until the desired alarm func-
tion (see the table above) is indicated in the display r.
4. Press the button A.O.T./SNOOZE s to set the weekdays
on which you require the alarm function:
You can choose between "workdays" (MON, TUE, WED,
THU, FRI), "weekends" (SAT, SUN) and "every day"
(MON, TUE, WED, THU, FRI, SAT, SUN).
5. If you hold the button A.O.T./SNOOZE s pressed down for
2 seconds, you can also, through repeated brief press-
ing of the A.O.T./SNOOZE s button, select a specic
weekday (e.g. only WED). The selected setting is indicated
in the display r.
6. To return back to the selection of “workdays“, “week-
ends“ or “every day“ hold down the button A.O.T./
SNOOZE
s again for 2 seconds.
7. Press the button MODE/BASS g to save the settings and
return to automatic modus.
When the alarm signal sounds...
and the alarm function "Radio" has been selected, the
•
radio plays for one hour at a pre-dened alarm volume.
and the alarm function "Signaltones" has been selected,
•
the signal tone sounds for 10 minutes, with an increasing
volume.
To switch o the alarm for approx. 9 minutes press the
•
A.O.T./SNOOZE button s.