- 12 -
• Then keep pressing the button "Video Out" on the remote
control until the Image reappears on the television screen.
- Brightness: Here you set the Brightness (1-16) of the
DVD player.
- Sharpness: Here you set the contrast (1-16) of the
DVD player.
- HD Resolution: Here you adjust several resolutions for
the HD output. Check using the playback
device's instruction manual which resolu-
tions (480p/576p/720p/1080i) are supported
- HD-JPEG Mode: Here you adjust the several resolutions
for the image display via the HD Output.
8.4. Audio settings
In this OSD-Menu you can administer the settings for Bass
Management, the size of individual loud speakers, Test Sound,
Delays, Digital Audio Outputs, Night Mode and ProLogic.
-Bass management: Here you can Activate/Deactivate the
Bass-Management. Activation (on) is
necessary if you are not using a 5.1 am-
plifier with its own speaker management
but rather want the sound output trans-
mitted via a particular amplifier. In this
case the DVD player must be informed
which kind of speaker (Small/Large) is to
be run from the respective sound output.
In this way the sound and the separation
of Highs, Middles and Basses can be opti-
mally conformed.
- Front, Center,
Surround,
Subwoofer LS: Here you can Activate/Deactivate the par-
ticular speaker type and set the size.
Large: Bass activated.
Small: Bass deactivate (Selectable only
when Bass Management is activa-
ted)
Small: No speaker connected
- Test tones: Here you can switch on a test sound for
each particular audio output in order to
check your 5.1 Surround settings.
- Delays Center,
Surround: Here you set the delays for the Centre
speaker and the rear Surround speakers.
Each increase in the distance setting corre-
sponds to a delay of one millisecond. With
optimal settings the sound reaches your
listening location at the same time from
all directions.
Centre: No delays, 0.3, 0.6, 1, 1.4, 1.7 m.
Surround: 1, 2, 3, 4 or 5.1 m
- Digital Output: Here you set the digital output signal of
the DVD player.
OFF: No digital audio component is
connected
PCM: a two channel digital audio com-
ponent is connected via coaxial
cable or optical cable.
RAW: a multi channel digital audio com-
ponent i.e. DTS receiver is connected
via coaxial cable or optical cable.
- Night mode: Here you activate/deactivate the night
mode. This setting allows for optimal
sound playback with reduced volume.
The louder transmissions are suppressed
and the quieter transmissions are played
back a little louder. This function is only
possible when using a digital audio com-
ponent.
- ProLogic: Here you set the Dolby ProLogic compa-
tibility.
OFF: No Dolby Prologic compatible audio
component is connected to the ana-
logue stereo output (L/R).
ON: A Dolby Prologic compatible audio
component is connected to the ana-
logue stereo output (L/R) of the DVD
player.
8.5. Rating settings
In this Menu you can administer the settings for the child lock
and change the password.
- Parental control: Here you set the child lock in three levels.
G: Only unrestricted DVDs can be played.
PG-13: No DVD with an age restriction
over 13 can be played.
Adults: All DVDs, including those with age
restrictions over 18 can be played.
KH 6515/6516
To Next Page
Loading...
