8
GB
6.3 Mixing/Chopping
CAUTION:
~ Mind the marking MAX for the maxi-
mum filling quantity.
~ Depending on the hardness and consist-
ency of the ingredients in the blender
jug|5/6, do not fill it to the maximum;
otherwise the blade attachment|7/8
could become clogged.
NOTE: if the smoothie is too thick, add a lit-
tle mineral water, fruit juice, milk or yoghurt
to suit your taste.
1. Place the fruit pieces and any other in-
gredients into the blender jug|5/6 as
desired. Mind the marking MAX for
the maximum filling quantity.
2.
Figure A:
screw the required blade at-
tachment|
7
/
8
onto the blender jug|
5
/
6
.
Ensure that the blade attachment is tightly
screwed to the blender jug.
3. Figure B: turn the blender jug|5/6
around and place it on the base unit|1.
The small noses|12 on the edge of the
blender jug fit into the recesses at the
head of the base unit|1.
4. Connect the mains plug|4 with the wall
socket.
5. A slight clockwise turn of the blender
jug|
5
/
6
switches the device on.
Let the device run for no more than
60|seconds.
6. A slight anticlockwise turn of the blend-
er jug|5/6 switches the device off.
Wait until the blade|7/8 has come to a
standstill.
7. Remove the blender jug|5/6 from the
base unit|1 and turn it around.
8. Unscrew the blade attachment|7/8
and ensure that the liquid drips into the
blender jug|5/6.
9. Before using it again and if necessary,
rinse the blade attachment|7/8 briefly
under running water.
10. Disconnect the mains plug|4 from the
wall socket.
11. Clean the device as soon as possible
after use.
6.4 Drink immediately
• Figure C: in order to drink the fresh
smoothie directly from the blender
jug|5/6, screw a To Go lid|9 on the
filled jug|5/6. Open the drinking clo-
sure|11 and drink from the opening for
drinking|10. After you have closed the
drinking closure|11 the opening for
drinking|10 and blender jug|5/6 are
tightly closed. You can also enjoy your
smoothie “to go” when you are out and
about.
6.5 Storage
• Figure C: smoothies are intended to be
consumed as soon as possible. For
short-term storage, screw a To Go lid|9
on the filled blender jug|5/6. Close the
drinking closure|11 if necessary. Then,
it is best to put the smoothie in the refrig-
erator.
6.6 Overheating protection
The device has an overheating protection
system. If the device has been in operation
for too long thus causing the device to be-
come too hot, it automatically switches off.
• In this case, pull out the mains plug and
allow the device to cool.
• You may then put the device back into
operation.
To Next Page
Loading...
