6
GB
WARNING! Risk of material
damage
~
Do not use the blade attachment with a
flat blade for liquids!
~ Thick or firm peels, (e.g. of citrus fruits,
pineapple), stems and pips of stone
fruits (e.g. cherries, peaches, apricots)
must be removed before blending.
~ Do not put any ingredients with a tem-
perature in excess of 85 °C into the
blender jug.
~ In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the blades of the blade
attachment rotate with difficulty or not at
all. Pull out the mains plug and investi-
gate whether there is an obstruction in
the blender jug or whether the contents
are too viscous. Also check whether the
device is assembled correctly.
~ Do not operate the device with empty
blender jugs, as this causes the motor to
overheat and may result in it being
damaged.
~ Only operate the device when a blade
attachment is screwed onto the blender
jug.
~ The device is designed for a maximum
operating time of 60 seconds without in-
terruption. After this, the device must re-
main switched off until it has cooled
down to room temperature.
~ Only use the original accessories.
~ The device (base unit, power cable with
mains plug) is not dishwasher-safe.
~ Do not use any astringent or abrasive
cleaning agents.
~ The device is fitted with non-slip plastic
suction feet. As furniture is coated with
a wide array of varnishes and synthet-
ics, and is also treated with different
care products, it cannot be fully ruled
out that some of these materials contain
ingredients that could attack and soften
the non-slip plastic suction feet. If neces-
sary, place a non-slip mat under the de-
vice.
4. Items supplied
1 base unit|1
1 blender jug large|5 (150 ml – 700 ml)
2 blender jugs small|6 (150 ml – 350 ml)
1 blade attachment|7 (cross blade)
1 blade attachment|8 (flat blade)
3To Go lids|9
1 recipe book|13
1 copy of the user instructions
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
5. How to use
• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Clean the device prior to its first
use! (see “Cleaning” on page 9)
• Unwind the desired length of cable from
the cable spool|3 on the underside of
the device.
• Place the device on a dry, level, non-slip
surface.
To Next Page
Loading...
