9 GB
Setting-up operation
Setting-up operation
Using the radio-controlled
socket (fig. B)
1. Put the radio-controlled socket into
any shuttered socket and connect
the appliance you want to operate.
2. Switch the electrical appliance on.
The radio-controlled socket can
only perform its switching function
when the device to be controlled is
switched on.
ATTENTION! FIRE HAZARD!
Do not attach any appliances which
could cause fires or other damaged
if left unattended when switched
on. The maximum load of every
radio-controlled socket is approx.
3.600 W. Any overload could cause
a risk of fire or damage to the device.
3. Press the manual ON / OFF button
5
to switch the remote-controlled
socket on directly on the appliance.
The LED operating status display
6
will shine. Alternatively, you can also
switch the remote-controlled socket
on using the remote control (See
“Using the remote control”).
4. Press the manual ON / OFF button
5
to switch the remote-controlled
socket off directly on the appliance.
The LED operating status display
6
will go out. Alternatively, you can
also switch the remote-controlled
socket off using the remote control
(See “Using the remote control”).
Using the remote-
control (fig. A)
1. Use the button ON / OFF
2
for
the channel whose device you would
like to switch on or off. The remote
control controls up to 4 radio-con-
trolled sockets (individually, in groups,
or all at the same time).
2. Use the ALL-ON / OFF button
3
to
switch all radio-controlled sockets on
or off at the same time.
Trouble-shooting
If the remote control does not
work, please check the follow-
ing points:
Prob-
lem
The operating indica-
tor
1
on the remote
control device illumi-
nates but there is no
reaction
Rem-
edy
· Check that the batteries
still have enough power.
If applicable put in new
batteries.
91210_silv_Funksteckdosen-Set_Content_DK.indd 9 18.07.13 10:13
To Next Page
Loading...
Need help?
General
