Silvercrest SBTF 10 C3 User Manual

SBTF 10 C3
GB
│
IE
│
NI
│
15 ■
Troubleshooting
If you cannot connect the hands-free appliance with a
compatible mobile telephone, proceed as follows:
Ɣ Ensure that the Bluetooth
®
function in the mobile
telephone is activated.
Ɣ Is the display flashing? Ensure that the hands-free ap-
pliance is correctly installed, switched on and supplied
with electricity.
Ɣ If you use several Bluetooth
®
appliances, ensure that
a previously created Bluetooth
®
connection of the
mobile telephone is separated. This may indicate that
a previously paired device is in range.
Ɣ Ensure that the hands-free appliance is distanced a ma-
ximum of 10 metres from the mobile telephone and that
there are no barriers or electronic devices between them.
Replacing the fuse
The hands-free set is equipped with a fuse. If the device
no longer works, check the fuse and replace if necessary.
Ɣ Open the vehicle connector plug  by turning the
fluted screw insert
A
gently anticlockwise – with pliers
if necessary – and remove it.
Ɣ Remove the plug tip
B
from the fuse
C
and pull the fuse
out. Ensure that the spring
D
in the vehicle connector
plug  does not accidentally jump out and become lost.
Ɣ Place a new fuse of type F2AL/250V into the vehicle
connector plug , place the plug tip
B
onto the end
of the fuse that is slightly protruding
C
and screw the
screw insert that you removed earlier
A
back in.
D
C B A

Silvercrest SBTF 10 C3 Specifications

General

Brand	Silvercrest
Model	SBTF 10 C3
Category	Automobile Accessories
Language	English