SilverCrest SBTH 4.1 A1
12 - English
Beeps
For specific events, the headphones emit acoustic signals which are indicated
in the following table:
Event Acoustic signal
Power-on procedure Melody
Power-off procedure Melody
Pairing completed Melody
Bluetooth
®
connection
established
Melody
Incoming call Ringtone
Minimum volume reached Beep
Maximum volume reached Beep
Low battery charge 4 beeps sound every 20 seconds
First use
Switching the headphones on/off
Switch on the headphones by pressing the ▸ll button (2) for approximately 4
seconds. The LED (8) flashes orange and thus indicates standby mode. If the
headphones were switched on for the first time and had never been connected
to a device, pairing mode is started automatically. The LED (8) alternates
between flashing blue and orange in pairing mode. Read the next section
when connecting your device.
Press the ▸ll button (2) for approximately 4 seconds to switch off the
headphones. The LED (8) flashes orange repeatedly when you switch off the
device.
To Next Page
Loading...
