Silvercrest SCAA 5.00 A1 - Setting the Time-Lapse Delay

SilverCrest SCAA 5.00 A1
English - 105
Setting the time-lapse delay
To set the time-lapse delay, proceed as follows:
 Press the On/Off/Mode button [2] multiple times to select the SETUP menu and then
press the record button [9] to confirm.
 Press the On/Off/Mode button [2] multiple times until the LAPSE menu is highlighted.
Press the record button [9] to open the LAPSE menu.

 Press the On/Off/Mode button [2] to select an option. The following settings are
available: ”1 SEC”, “3 SEC”, “5 SEC“, “10 SEC“, “30 SEC“ and “60 SEC“.
 Press the record button [9] to confirm your selection.
 To exit the SETUP menu, press the On/Off/Mode button [2] multiple times until the EXIT
item is highlighted and then press the record button [9] to confirm.