SDBE 2600 A1
GB
│
IE
│
NI
│
7 ■
Plugging in and ironing
Dry ironing without steam is possible at all tempera-
tures, steam ironing is only possible from the setting
range on the temperature control .
■ Insert the plug into a mains power socket.
CAUTION! PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing,
(
symbol), the clothing item may not be
ironed. Ignoring this warning could lead to
permanent damage to the clothing item.
■ Check the care instructions on the labels in
garments to see if they are suitable for being
ironed, and at which temperature setting.
Temperature
control
icon
Type of Material
Acrylic, rayon
Silk, wool,
polyester mix fabrics
Cotton, linen,
viscose
■ Select the appropriate temperature setting using
the temperature control .
NOTE
While it is heating up, always place the iron on
the base .
If you place the iron down on its sole and do
not move it, the automatic switch-off will be acti-
vated after 30 seconds (see chapter "Automatic
switch-off") and the appliance stops heating.
The temperature control lamp lights up. When
the control lamp goes out, the set temperature
has been reached.
■ Wait until the temperature control lamp
goes out.
■ To moisten the laundry, press the spray
button
.
This function is suitable for very dry and very
crumpled garments.
Steam ironing
■ Set the steam control to the desired steam
setting.
■ The temperature control must be set to at
least the setting
. Otherwise no steam can
be produced.
Ironing with steam blast
The steam blast function is especially suitable for
smoothing difficult-to-reach parts of a garment.
■ Raise the steam iron slightly.
■ For a steam blast, press the steam blast
button
.
You can also use the steam blast function to smooth
hanging textiles.
Hold the iron vertically and press the
steam blast button
.
Putting the steam iron down
RISK OF FIRE!
► Never leave a hot steam iron unattended if
it is switched on or connected to the mains
power supply.
To Next Page
Loading...
Need help?
General
