EasyManuals Logo

Silvercrest SDBE 2600 A1 User Manual

Silvercrest SDBE 2600 A1
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
SDBE 2600 A1
8 
GB
IE
NI
Move the temperature control to the "MIN"
position.
Stand the steam iron only on the base .
After use
Remove the power plug from the mains power
socket.
Empty the water tank and clean the sole of the
iron .
Place the cooled-down steam iron on the base .
Automatic descaling function
(ANTICALC)
There is a descaling cartridge in the water tank that
helps reduce the build-up of limescale.
This descaling cartridge is a permanent fixture in
the water tank and cannot be replaced.
Drip-Stop function
With conventional steam irons, water can drip from
the sole of the iron at low temperatures.
This iron, however, possesses a new feature: the
DRIP-STOP function ( ). At low tem-
peratures the iron automatically switches off the
steam-blast function.
Then set a suitable temperature with the tempera-
ture control . As soon as this is reached, steam
production is resumed.
Automatic switch-off
This steam iron is fitted with an automatic switch-off
system. This stops the iron from heating up.
If the iron is resting on its sole and is not moved
for about 30 seconds, there will be a warning beep
and the control lamp for the automatic switch-off
flashes. The iron will stop heating up. To deactivate
the automatic switch-off, lift up the iron and move
it gently from side to side. The control lamp for the
automatic switch-off goes out and the iron will
heat up again.
If the iron is resting on its base and is not moved
for about 8 seconds, there will be a warning beep
and the control lamp for the automatic switch-off
flashes. The iron will stop heating up. To deactivate
the automatic switch-off, lift up the iron and move
it gently from side to side. The control lamp for the
automatic switch-off goes out and the iron will
heat up again.
NOTE
The automatic switch-off is not intended as a
substitute for removing the plug from the mains
power! This is merely intended to reduce the fire
hazard if you forget to switch of the iron!
Cleaning
Self-cleaning function
Fill the water tank to the "MAX" marking.
Insert the plug into the mains power socket.
Move the temperature control to the "MAX"
position.
Set the steam control to maximum steam
power.
Allow the steam iron to heat up until the heat
control lamp goes out and then lights up
again.
Hold the steam iron horizontally over a suitable
container.
Press and hold down the self-clean button -.
Move the steam iron back and forth a little.
Steam and boiling water will flow from the
steam exit holes in the sole of the iron . Any
impurities that may be present are flushed out.
Release the self-clean button - as soon as all
of the water has flown out of the water tank.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SDBE 2600 A1 and is the answer not in the manual?

Silvercrest SDBE 2600 A1 Specifications

General IconGeneral
BrandSilvercrest
ModelSDBE 2600 A1
CategoryIron
LanguageEnglish

Related product manuals