EasyManua.ls Logo

Silvercrest SDM 1500 C2 - Safety Instructions - Electrical Hazards; Risk of Electric Shock Warnings

Silvercrest SDM 1500 C2
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
IE
NI
 3
SDM 1500 C2
Safety instructions
RISK OF ELECTRIC SHOCK!
Connect the appliance only to mains power sockets supplying
a mains power voltage of 220 - 240 V
~
, 50/60 Hz.
In the event of operating malfunctions, and before cleaning
the appliance, disconnect the plug from the mains power
socket.
To disconnect the power cable, always pull the plug from the
socket, do not pull the power cable itself.
Do not kink or crush the power cable, and route the cable
so that it cannot be stepped on or tripped over.
To avoid risks, arrange for defective plugs and/or power
cables to be replaced at once by qualifi ed technicians or
our Customer Service Department.
Make sure that the power cable does not become wet or
damp during use. Route the cable in such a way that it
cannot be crushed or damaged.
To prevent risks, stop using the appliance immediately if it
is damaged.
Disconnect the appliance from the mains power socket before
lling it with water, changing accessories or cleaning it.
Use the appliance only in dry indoor areas, not
outdoors.
Never submerse the appliance in water or other liquids!
Never aim the steam jet directly at electrical appliances or
equipment which contains electrical components, such as
the interior of ovens.

Table of Contents

Related product manuals