Silvercrest SEMS 1100 B2 - Cleaning the Milk Frother; Milk Frother Casing Removal

GB
│
MT
│
41 ■SEMS 1100 B2
Cleaning the milk frother
CAUTION! PROPERTY DAMAGE!
► NEVER use abrasive, corrosive or chemical agents to clean the appliance.
These could damage the outer surfaces of the appliance.
1) Place an empty container under the milk frother 6.
2) Turn the steam control 2 to
immediately after use and let the steam escape
for a few seconds.
3) Close the steam control 2 (turn it towards “0” as far as it will go), switch the
appliance off and remove the plug from the mains power socket.
4) Allow the nozzle to cool down.
5) Pull the casing of the milk frother 6 off (Figure 1) and clean it thoroughly in
warm water.
6) Wipe the nozzle under the casing with a damp cloth. If necessary, add a little
mild detergent onto the cloth. After cleaning with detergent, always wipe off
with a cloth moistened with clean water. Ensure that there is no detergent
residue left on the nozzle.
7) Push the casing back onto the nozzle (Figure 1).
Figure 1