23 GB/IE/NI
Precision attachment
15
: Turn the adjusting wheel to the desired
length of the length sector (see Fig. C), length can be set between
1 mm and 11 mm at 1 mm intervals.
Comb attachment
16
: Press and slide the comb attachment
16
to
the desired length of the length selector (see Fig. D), length can be
set between 12 mm and 33 mm at 3 mm intervals.
If you are not used to trimming hair, begin with the highest setting
and then reduce the setting to avoid cutting your hair shorter than
you intended.
Guide the product slowly and steadily through the hair. Do not
guide the product through the hair faster than the hair can be cut.
Regularly shake or blow off the hair trimmings. If too much hair
gets caught in the precision attachment
15
or comb attachment
16
, remove it and clean it.
To prevent the precision attachment
15
or comb attachment
16
from becoming clogged, clean it regularly using the cleaning
brush
18
(see Fig. F).
Cleaning and care
A timer built into the product adds the trimming times. After 30 minutes
of trimming, the cleaning symbol
10
will start flashing in the display
6
.
This reminds you to thoroughly clean the product, which is required
regularly. If you switch off the product whilst the cleaning symbol
10
is
flashing, the trimming timer will restart.
Never immerse the product, the supply cord or the power adapter
14
in water or other liquids during corded use or rinse under running
water.
Always switch off the product before cleaning it.
The cutting unit
1
can be cleaned with water. Do not use any
other liquids.
To Next Page
Loading...
