18
GB
Using Programs
NOTES:
• Make sure that the food will not touch
the hot heating element2 at the top of
the interior and become stuck there.
•
QUICK START FUNCTION
Switch the device on from standby mode
with the Start/Stop button
20
. Press
the Start/Stop button again to start
cooking at the preset temperature
180 °C
for the preset cooking time
15 min
.
1. Prepare the foods and place them in the
frying basket5.
2. Place the frying basket5 in the pan10.
3. Slide the pan10 into the housing1.
4. Switch on the device with the Start/Stop
button 20.
5. Press the Menu button 23 repeated-
ly to select the desired program. The
corresponding symbol flashes.
6. Start the cooking process with the Start/
Stop button 20.
Interrupting the cooking process
You can interrupt the cooking process at any
time, e.g. to check the degree of browning.
1. Take the pan10 by the handle9 and
remove it from the housing1. When the
pan is taken out, the device automatical-
ly switches itself off.
2. Reinsert the pan10 into the device. The
device switches on again automatically
until the cooking time has expired.
End of the cooking process
• An audio signal sounds when the pro-
gram has finished. The fan continues to
run for approx. 1 minute.
• You need a heat-resistant surface for the
pan10 and the frying basket5 and a
plate or bowl (pre-heated if necessary).
• To disconnect the device from the mains
pull the mains plug11 after use.
1. Use the handle9 to pull the pan10 out
of the housing1. Place the pan10 on
the heat-resistant surface.
2. Figure A: slide the safety catch7 in
the direction of the arrow.
3. Press the button for unlocking the frying
basket8 and lift the frying basket5 up-
wards out of the pan10.
4. Place the frying basket5 on the heat-re-
sistant surface. Place the food on the
prepared plate / in the prepared bowl.
5. Allow the device and accessories to
cool down before cleaning them.
__352840_2010_KURZ_B8.book Seite 18 Dienstag, 26. Januar 2021 10:24 10
To Next Page
Loading...
