SHSS 16 A1■ 6
│
GB
│
IE
│
NI
│
CY
Before first use
■ Remove all packaging materials and protective
stickers from the appliance, especially the
protective sticker on the contacts on the back of
the hand element 4.
■ Place the cradle g onto the stand so that the
cradle g clicks into place.
NOTE
► This appliance is supplied with non-charged
batteries. The batteries must be charged for
5–6 hours before using the appliance for
the first time.
Charging the appliance
NOTE
► Ensure that the appliance is switched off
before starting to charge the batteries.
■ To charge the appliance, connect the charger p
to a mains socket. Plug the barrel plug a into
the charging socket f on the underside of the
cradle g. Feed the cable through the recess on
the rear of the cradle g so that the cradle g is
not resting on the cable.
■ Place the handle with the attached hand
element 4 onto the cradle g.The charge
indicator lamp 3 lights up red. When the
appliance is fully charged, the indicator light 3
lights up green.
■ Do not recharge the batteries until the suction
power of the appliance has become noticeably
weaker.
NOTE
► When the batteries are weak, the charge
indicator lamp 3 starts flashing green.
When this happens, the appliance can be
operated for another 3 to 5 minutes.
► Once the batteries are completely
discharged, the charge indicator lamp 3
flashes red five times and the appliance
switches off.
Assembly/disassembly
Connecting the hand element to the
handle/removal from handle
Fig. 1 Fig. 2
■ To connect the hand element 4 to the handle,
push the tip of the hand element 4 into the
opening in the hand element recess r.
■ Then press the grip 1 of the hand element 4
into the handle so that the hand element 4
clicks firmly into position (Fig.1).
■ To remove the hand element 4 from the handle,
press the release buttons
e.
■ Then pull the hand element 4 upwards and
forwards out of the hand element recess r
(Fig. 2).
To Next Page
Loading...
Need help?
General
