Silvercrest SKM 350 A1 - Installation; Operation

7
GB
6. Installation
DANGER! Risk of injury from
cutting!
~ The blade insert8, the grating disk5
and slicing insert4 are sharp. Handle
with care.
~ Only plug the mains plug14 into the
wall socket after the food processor has
been completely assembled.
NOTE:
• The device is equipped with a safety
switch. The bowl11 can only be
locked with a closed lid3 and can only
be put into operation once it's locked.
1. Figure A: place the bowl 11 on the mo-
tor block
15 . The symbol  16 points to
the bottom marking on the bowl
12 . Do
not turn the bowl.
2. Place the drive axle9 in the bowl.
3. Figure E: if required, place the slicing
insert4 / grating disk5 into the insert
holder6.
4. Place the dough blade7, the blade in-
sert8 or the insert holder6 with at-
tached slicing insert4 / grating disk5
on the drive axle9.
5. Dough blade7 / Blade insert8: Fill the
prepared foodstuffs into the bowl11,
as desired.
6. Figure A+B: place the lid3 on the
bowl11. The symbol 2 points to the
top marking on the bowl10.
7. Figure B+C: turn the lid3 in a clock-
wise direction as far as it will go, until
the symbol 2 points to the top mark-
ing on the bowl10.
8. Figures C+D: turn the bowl11 in a
clockwise direction as far as it will go,
until the symbol 16 points to the bot-
tom marking on the bowl12.
9. Insert the mains plug 14 into a wall sock-
et corresponding to the technical data.
7. Operation
DANGER! Risk of injury from
cutting!
~ T
he insert holder 6 , the blade insert 8
and the
dough blade  7 keep on turning
after the device has been turned off.
Please wait until all parts have come to
a standstill before unlocking the
bowl11 and opening the lid3.
~ The device must never be operated with-
out the bowl11.
WARNING! Risk of material dam-
age!
~ In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the insert holder6, the
blade insert8 and the dough blade7
are not turning or are turning with diffi-
culty. If this happens, pull out the mains
plug14 and check whether there is
something in the bowl11 blocking
movement or whether the food is too
tough. Also check whether the device is
assembled correctly.
CAUTION:
~ Depending on the hardness and consist-
ency of the foodstuffs, do not fill the
bowl11 to the maximum, as the insert
holder6, the blade insert8 and the
dough blade7 could get blocked. Pay
attention here to the guideline values for
various foods in the "Processing table"
section.
NOTE:
• For chopping harder foodstuffs, use the
setting P. Work with short pulses
(1 pulse: turn on P for approx. 1 sec-
ond).
The number and length of the puls-
es will depend on the quantity and
consistency of the food .
__CPE273409_Kuechenmaschine_B6.book Seite 7 Dienstag, 17. November 2015 12:15 12