■ 8 │ GB
│
IE
│
NI
SKV 1200 B2
7) Turn the rotary switch 3 to the desired setting.
NOTE
► The ideal speed depends on the consistency
of the items being mixed. The more liquid the
contents are, the faster you can mix them.
► For short, powerful pulsed operation, turn
the rotary switch 3 anticlockwise to level P.
Level P does not lock into place so as not
to overload the motor. You should therefore
keep the rotary switch 3 in this position only
for a short time.
CRUSHING ICE
► In order to produce crushed ice, place ice
cubes in the blender t, close it and turn the
rotary switch 3 approx. 7 times to level P
for 5 seconds. You may need to adapt the
above instructions depending on the quantity
and size of the ice cubes.
Adding more ingredients
1) Turn the appliance off using the rotary switch 3.
2) Remove the blender lid r and add the ingredi-
ents
or
3) Turn the measuring cup e in the blender lid r
clockwise as far as it will go and then take it
out. Add the ingredients gradually through the
opening in the blender lid r.
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch 3
(Position “0”).
2) Turn the blender t clockwise so that the
symbol on the blender t is pointing to the
symbol on the appliance and remove it.
NOTE
► Ideally, you should clean the blender t im-
mediately after use (see the section "Cleaning
and care"). This makes food residues easier
to remove.
3) Place the drive protection cover u back on
the blender drive i so that the
symbol on
the drive protection cover u is pointing to the
symbol on the appliance. Turn the drive
protection cover u anticlockwise so that the
symbol on the drive protection cover u is
pointing to the
symbol on the appliance.
Working with special accessories
NOTE
► The special accessories, such as a meat
grinder attachment, a noodle attachment and
vegetable grater, can be ordered online at
www.kompernass.com.
ATTENTION! PROPERTY DAMAGE!
► The drive unit for special accessories o
should only be used for accessories which
are specifically approved for use with this
appliance by the manufacturer.
1) Turn the appliance off using the rotary switch 3
(Position “0”).
2) Push the cover over the drive unit for special
accessories o upwards and remove it from
the appliance.
3) Attach the special accessory to the appliance
in accordance with its operating instructions.
ATTENTION! PROPERTY DAMAGE!
► Never use special accessories at the same
time as the mixing bowl 6 or blender t!
This will overload the motor!
After you have finished using
your appliance
1) Turn the appliance off using the rotary switch 3
(Position “0”).
2) Disconnect the special accessory from the ap-
pliance as stated in its operating instructions.
3) Clean all components as described in the
section “Cleaning and care”.
4) Place the cover for the drive unit for special
accessories o back in position.
To Next Page
Loading...
