GB│IE│NI │ 11 ■
SLE 265 B3
Handling and use
This section provides you with important information on handling and using the
appliance.
Switching the appliance on/off
♦ Press the STAND-BY button
20
to switch on the appliance.
You will hear a beep and the OPERATION LED
19
lights up.
♦ Press the STAND-BY button
20
to switch off the appliance.
You will hear a beep and the OPERATION LED
19
goes out.
NOTE
► The appliance starts in the mode last selected.
► After a power failure, if the appliance is disconnected from the mains, or
after switching off owing to the overheating protection, the appliance
restarts in the mode last selected.
♦ If a timer has been programmed, the appliance switches off definitively
upon lapse of the time specified (1–24 hours).
♦ If the relative humidity value has been defined in the TARGET HUMIDITY
programme, the appliance switches off once the value has been attained.
If the value is exceeded, the appliance switches on again.
♦ The appliance switches off if the water tank
4
is full or has been removed.
If wrongly positioned, or if the water tank
4
has been removed, the TANK
FULL LED
16
flashes and you will hear a beep if the appliance is switched on.
NOTE
► The water tank
4
must be fully inserted in the appliance; otherwise, the
condensate cannot be collected properly.
Air outlet valve
There is an adjustable valve
2
on the air outlet on the
upper side of the appliance that you can open. You can
set the valve
2
at various angles to determine the air
flow. This can be helpful if you are using the appliance
to dry washing, for example. In this way, you can direct the air flow towards the
wet laundry.
To Next Page
Loading...