EasyManua.ls Logo

Silvercrest SLE 265 B3 - Water Tank Operations; Water Tank Indicators

Silvercrest SLE 265 B3
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GBIENI15
SLE 265 B3
Water tank
The water tank
4
has a capacity of approx. 6.5 litres. The water level is indicated
on the front of the water tank
4
. The appliance may only be operated once the
water tank
4
is inserted. If the water tank
4
is full, the TANK FULL LED
16
will
flash and the appliance will beep for about 20 seconds. The appliance switches
off after a few seconds. The TANK FULL LED
16
flashes until the water tank
4
is
emptied and replaced in the appliance.
Pull the water tank
4
out of the appliance using the grips on the side.
Use the grips to carry the water tank
4
(see figure 1).
Fig. 1
Tip out the water and replace the water tank
4
into the appliance. The
appliance continues in the previously set programme for about 3 minutes.

Table of Contents

Related product manuals