GB│IE│NI │ 21 ■
SLE 265 B3
Fault Possible cause
Remedy
The appliance
is producing
no or too little
condensate.
The air inlet or air outlet
aperture is contaminated or
obstructed.
Ensure that the air inlet and air outlet
apertures are clean and free of
obstructions.
The room's windows and doors
are open.
Close the windows and doors.
Is the appliance running in the
AIR CLEAN programme? Dehu-
midification is not taking place.
Select a different programme, e.g.
AUTOMATIC.
The air ejected
is warm.
Heat exchange process
This is a normal feature of the appli-
ance.
The error code
E 1 is flashing on
the display
15
.
Temperature sensor error
Contact the Customer Service depart-
ment.
The error code
E 2 is flashing on
the display
15
.
Humidity sensor error
Contact the Customer Service depart-
ment.
NOTE
► If the solutions presented above do not resolve the problem, please contact
Customer Service (see section Service).
To Next Page
Loading...