SNS 45 B4
GB
│
IE
│
NI
│
CY
│
23 ■
NOTICE
► After the expiry of the preselected treatment time the UV lamps are switched
off automatically.
► The start button 4 and the time selector button 3 must be activated again
for each new treatment.
Ƈ Examine each nail, after the application and hardening of all coatings, for
unevenness, small scratches or ridges.
Ƈ If you discover unevenness, apply a further thin layer of UV gel i and
harden the nail with the setting of 150 seconds or 90 seconds (depending
on the amount of applied UV gel i).
Even after the last hardening of the Gel layer, the nails may feel a feel sticky
(“sweat-layer” or polymerization layer).
Ƈ Moisten a cellulose pad w with finishing solution z and then wipe this
over the nail.
To Next Page
Loading...
