Silvercrest SOPE 650 A1 - Page 32

GB
│
IE
│
29 ■
SOPE 650 A1
♦ Close the lock  by pushing it in the direction of the symbol as far as it will
go. You may have to wiggle the press screw housing  a little in order to
close the lock .
♦ Fold the swivel arm  down to the stop.
♦ Place the funnel  on the appliance so that the outlet and the feet on the
funnel are inserted in the appropriate holders in the motor unit 6. Push
down the funnel  until it clicks audibly into place and is seated firmly on the
motor unit 6.
♦ Place the lid  on the funnel  if you do not want to use the appliance
immediately. Place the lid  on the funnel  in such a way that the lock
on the lid  engages in the receptacle on the funnel .
Disassembling the appliance
WARNING!
► Parts of the appliance become hot during operation! Allow the appliance
to cool sufficiently before disassembling!
♦ Disconnect the mains plug from the mains socket and from the mains
connection 0of the appliance.
♦ Remove the lid  from the funnel .
NOTE
► Make sure that there are no more ingredients in funnel  before removing
it from the appliance. The outlet of the funnel is open!
♦ Tilt the funnel  slightly towards the swivel arm  to release it from the
lock . Then pull it upwards.
♦ Fold the swivel arm  up to the stop.
♦ Hold the press screw housing  firmly and slide the lock  in the direction
of the
symbol. Remove the screw press  from the mounting together with
the housing .
♦ Pull the press screw  out of the housing .