Silvercrest SOR 2400 D2 - Frost Protection Function

11 GB/IE/NI
Turn the heat level switch
2
to “0” then turn
the temperature control
3
to MIN.
Remove the mains plug from the mains
socket.
Frost protection function
The frost protection function
automatically controls the product to
keep the room temperature above 7°C,
steps are as follows:
Connect the mains plug into a mains socket.
Set the heat level switch
2
to either “1”, “2”
or “3”.
Set the Temperature control
3
to MIN.
Note: The product will switch itself on and off
automatically to maintain a temperature higher
than 7°C.
Use the heating fan only
To use the hot air outlet
5
only on the
product, steps are as follows.
Connect the mains plug into a mains socket.
Press the heating fan switch
4
to position
“I” to switch on the hot air outlet
5
. An
indicator in the heating fan switch
4
will
light up. Hot air will be blown through the hot
air outlet
5
.
To switch off the hot air outlet
5
, press the
heating fan switch
4
to “0” position.
Care and cleaning
Let the product to cool down
before cleaning.
Never immerse the product,
power cord or mains plug into water.
Remove the mains plug from the mains socket
and leave the product to cool completely
before cleaning.
Use a damp lint-free cloth to clean the product.
Use a mild detergent on the cloth for
stubborn dirt.
Do not use abrasive, aggressive or chemical
cleaning agents. It could damage the surfaces
of the product.
Storage
If the product not to be use for a long period
of time, clean it as described in the section
“Care and Cleaning”.
Wind the power cord around the power cord
retainer
7
clockwise tightly and let the
mains plug being held at the upper part of
power cord retainer
7
, see fig D.
Store the product at a clean and dry location.
Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
The Green Dot is not valid for Germany.
b
a
Observe the marking of the packaging
materials for waste separation, which
are marked with abbreviations (a)
and numbers (b) with following
meaning: 1–7: plastics / 20–22:
paper and fibreboard / 80–98:
composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.