Silvercrest SPM 220 A1 User Manual

GB
│
IE
│
NI
│
CY
│
7 ■
SPM 220 A1
Assembling the appliance
NOTE
► Before first use, clean all parts of the appliance
as described in the section Cleaning.
1) Set up the appliance on a flat surface near a
mains socket that is easily accessible. There
should be enough space in front of the appli-
ance for a bowl or similar to catch the pasta.
2) Push the dough containert into the appliance
base5 as far as the stop. The tabs on the
dough containert must be pushed into the
corresponding slots in the rear wall.
3) Guide the kneading hook9 into the dough
containert from above and insert it into the
drive shaft6.
4) Push the supportq into the end of the
bracketw so that the three tabs on the
supportq slide into the grooves on the
bracketw (fig. 3).
0
q
w
9
Fig. 3
5) Mount the bracketw onto the dough
containert. Push in the bracketw so that its
narrow end goes through the round opening
on the dough containert (fig. 3).
The bracketw only fits into the opening in one
position; the markinge must point towards
the
symbol on the dough containert.
Turn the bracketw clockwise until the
markinge on the bracketw points to the
symbol (fig. 4):
w
e
Fig. 4
6) Then push the dough shaft0 with its narrow
end through the bracketw into the retainer
on the kneading hook9 (fig. 3). If necessary,
reach into the dough containert from above
and wiggle the kneading hook9 a little until
you can push in the dough shaft0.
7) Place the front panelz onto the dough
containert and push it firmly into place. The
catches on the front panelz must slide into in
the corresponding recesses on the dough
containert.
8) Select the appropriate shaping disc8 (see
section Shaping discs) and slide it onto the
bracketw so that the two catches on the
shaping disc8 slide into the recesses on the
bracketw.
9) Push the shaping disc fixturer onto the
bracketw and tighten it by turning it clockwise
towards the
symbol. Fix the shaping disc8
in place with your free hand if necessary.
10) Do not fit the lid 2 until after you have placed
the required amount of flour in the dough
containert (see section Making pasta).
11) Insert the plug into an easily accessible mains
socket. You will hear a beep and the display a
lights up briefly. The appliance is now in
standby mode.
The appliance is now assembled and ready for
operation.
IB_385824_SPM220A1_LB6-.indb 7 14.10.2021 09:11:06

Silvercrest SPM 220 A1 Specifications

General

Brand	Silvercrest
Model	SPM 220 A1
Category	Pasta Maker
Language	English