Silvercrest SPPB 5000 A1 User Manual

SPPB 5000 A1
■ 10 │ GB│IE│NI
Handling and use
Charging mobile devices with the power bank
♦ Insert the micro-USB plug on the charging cable into the
micro-USB charging port on the mobile device, and insert
the USB plug into the USB port
on the power bank.
♦ Press the ON/OFF button
to start the charging process.
NOTE
► After removing the lighting attachment
, you have the option
of charging a second device parallel to the first one. Keep in
mind that the capacity of the power bank diminishes faster
and the charging times become longer.
CAUTION
► If you charge two mobile devices simultaneously at the USB
ports (
+ ), the total power consumption of the two
mobile devices must not exceed 2.1 A.
♦ Press the ON/OFF button
for approx. 3 seconds to start
the charging process at the USB port
.
♦ During the charging process, the current charge level of the
power bank is shown via the charge level LEDs
(see table
in the section "Checking the charge level").
♦ To stop charging, disconnect the charging cable
from the
mobile device and the power bank. The charge level LEDs
switch off after about 30 seconds.
IB_286204_SPPB5000A1_DE-95x140_LB6.indb 10 24.05.17 16:26

Silvercrest SPPB 5000 A1 Specifications

General

Brand	Silvercrest
Model	SPPB 5000 A1
Category	Accessories
Language	English