SPPB 5000 A1
GB│IE│NI │ 11■
Using the power bank as a light
The power bank has a lighting attachment .
♦ Place the lighting attachment
on the power bank.
♦ Press the ON/OFF button
for approx. 3 seconds to switch
lighting attachment on or off.
NOTE
► The power consumption of the lighting attachment
is
150 mA. When using the lighting attachment , the second
USB port may only be loaded with maximum 1.95 A.
Troubleshooting
The power bank does not charge
♦ Cable connection faulty. Check the connection.
A connected device will not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button
to start the charging process.
♦ The charging current of the connected device is too low
(< 50 mA) or too high (> 2.1 A).
♦ The internal overcurrent protection has been triggered.
Disconnect the attached device and connect the micro-USB
charging port
to a power source for a short while (see
section Charging the power bank).
Afterwards, the power bank can be used again.
IB_286204_SPPB5000A1_DE-95x140_LB6.indb 11 24.05.17 16:26
To Next Page
Loading...
