Cordless shaving
This appliance is not suitable for wet
shaving!
This shaver can be used without the power cable. In this
case, you must charge the appliance before first use
(see section "Charging the battery").
1) Ensure the cutter block 2 is attached and locked in
place.
2)
R
emove the protective cap 1.
3) Press the switch lock 7 and push the on/off switch
6 towards the cutter block 2. The green power
light 8 lights up and the shaver starts.
Best results are achieved if used on dry skin.
It can take 2 to 3 weeks until the skin is accustomed to
the dry shaving system.
4) Move the shaving heads with straight and circular
motions over the skin.
5) After you covered all the areas you want to shave,
set the on/off switch 6 back into its initial position.
The appliance stops and the green power light 8
turns off.
To Next Page
Loading...
