Long hair trimmer
■ Clean the long hair trimmer 3 after every use with
the supplied brush e.
■ Oil the long hair trimmer 3 approximately every
6 months with a drop of sewing machine oil.
Cleaning under running water
1) Press the release button 4 so that the cutter block 2
pops open.
2) Stretch out the cutter block 2 past the initial locking
position until it can be pulled upwards and off.
3) Hold the cutter block 2 under running water so that
the water flows through the shaving heads from the
inside to the outside.
Hold only the cutter block 2 under
running water! The shaver handset can be damaged
irreparably if it is held under running water.
To Next Page
Loading...
