5) Replace the cutter block 2. Refer to figure 1 for
assistance:
– Insert the 3 shaving heads in the recesses of the
cutter block 2. Ensure that the notches on the
edge of the shaving heads rest on the catches in
the opening.
– Place the round blades into the shaving heads.
– Replace the shaving head holder, press it down a
little and slightly turn the gear wheel clockwise.
If the holder for the shaving heads cannot be reat-
tached, it may be that the gear wheel is a little skew.
In this case, turn the gear wheel counter-clockwise
again up to the stop. The holder for the shaving heads
can then be fitted.
The cutter block
2
is now installed again.
6) Remove loose hairs from the shaver with the brush e.
7) Replace the cutter block 2 on the shaver. Ensure
that it snaps into place and is seated firmly.
■ Clean the housing with a damp cloth.
To Next Page
Loading...
