Silvercrest SRR 3.7 C3 - Cleaning Cutting Unit with Brush

■ 14
│
GB
│
IE
│
NI
│
CY SRR 3.7 C3
2) Tap the cutting unit  on a flat surface or blow off the hair
cuttings.
3) Use the brush ! to remove any remaining hair cuttings.
4) Replace the cutting unit  flush on the appliance. Ensure that it
snaps into place and is seated firmly.
Long hair trimmer
■ Clean the long hair trimmer  after every use with the supplied
brush !.
■ Oil the long hair trimmer  around every 6 months with a drop
of sewing machine oil.
Cleaning under running water
1) Take hold of the cutting unit with three fingers in the grip
recesses and pull it off.
2) Hold the cutting unit  under the running water so that the water
flows through the shaving heads from the inside to the outside.
CAUTION! MATERIAL DAMAGE!
Hold only the cutting unit  under running water! The shaver
handset can be damaged irreparably if it is held under running
water.
3) Allow the cutting unit  to dry.
4) Replace the cutting unit  flush on the appliance. Ensure that it
snaps into place and is seated firmly.
Thorough cleaning
To clean the appliance thoroughly, disassemble the three cutting
heads:
1) Take hold of the cutting unit with three fingers in the grip
recesses and pull it off: