Silvercrest SRR 3.7 C3 User Manual

GB
│
IE
│
NI
│
CY
│
17 ■
SRR 3.7 C3
NOTE
If...
– ... the shaving result is noticeably poorer, ...
– ... you have to the shave the same spot repeatedly
to achieve a good result, ...
– ... the shave takes much longer than usual, ...
– ... there is visible damage to the shaving heads, ...
... the shaving heads/the cutting unit  must be replaced.
You can order the cutting unit , incl. shaving heads from
our customer service (see section “Ordering spare parts”).
To replace the cutting unit  proceed as follows:
1) Take hold of the cutting unit with three fingers in the
grip recesses and pull it off.
2) Fit the new cutting unit  onto the shaver. Ensure that it
snaps into place and is seated firmly.
Travel lock
This appliance is fitted with a travel lock. You can lock the On/Off
switch  to prevent accidental starting:
Press and hold the On/Off switch
 for around 3 seconds, until
the symbol  lights up blue. The On/Off switch  is now
locked.
To unlock the appliance, press and hold the On/Off switch 
for around 3 seconds, until the symbol  lights up blue five times.
NOTE
If you attempt to switch the appliance on while the travel lock
is activated, the
symbol  lights up blue once.
The appliance will not start.

Silvercrest SRR 3.7 C3 Specifications

General

Brand	Silvercrest
Model	SRR 3.7 C3
Category	Electric Shaver
Language	English