Silvercrest SRR 3.7 C3 - Thorough Cleaning and Reassembly

■ 16
│
GB
│
IE
│
NI
│
CY SRR 3.7 C3
3) Clean all parts under running water and then allow them to dry fully.
4) Reassemble the cutting unit . Use the following illustrations for
guidance:
– Place the three shaving heads in the recesses of the cutting
unit . Ensure that the notches on the edge of the shaving
heads rest on the catches in the opening.
– Place the round blades into the shaving heads with the blade
tips to the front.
– Press the two tabs of the retainers together and place them
back into the catches of the cutting unit  and release the tabs.
The cutting unit  is now reassembled.
5) Remove loose hairs from the shaver with the brush !.
6) Replace the cutting unit  on the shaver. Ensure that it snaps
into place and is seated firmly.
■ Clean the housing with a moist cloth.