Silvercrest SRR 3.7 C4 - Cleaning Under Running Water

GB
IE
16
SRR 3.7 C4
Cleaning under running water
The cutting unit  is suitable for cleaning under running
water.
1) Pull the cutting unit  off the handset.
2) Press the release button  so that the cutting unit  pops open.
3) Hold the cutting unit  under the running water so that the
water flows through the shaving heads from the inside to the
outside.
CAUTION! MATERIAL DAMAGE!
► Ensure that only the shaver unit  is under the stream of
water! The shaver handset is only protected against water
splashes and can be irreparably damaged if it is held under
running water.
4) Allow the cutting unit  to dry out completely before using the
shaver again.