SSM 180 A2
GB
│
IE
│
NI
│
7 ■
NOTE
If you clean the appliance directly after use, you
will usually achieve sufficiently hygienic cleaning
results for the blender jug and the blade
holder by using the following alternatives:
► Fill the blender jug with 400 ml of water
and add a few drops of mild detergent.
► Attach the blade holder and screw both
onto the base .
► Press the start button
a few times so
that the blade ploughs through the water.
► Afterwards, rinse the blender jug and the
blade holder with plenty of clear water
so that all detergent residues are removed.
■ After cleaning, dry all parts thoroughly.
■ Reassemble the blade holder :
– Place the plastic ring into the blade
holder so that the grey plate protrudes
through the slot in the blade holder .
– Place the sealing ring over it and press it
firmly into place.
If the sealing ring and the plastic ring are not
correctly fitted, the appliance will not start!
NOTE
► You can also clean the lid , the blender
jug and the blade holder with the
sealing ring and the plastic ring in
your dishwasher. If possible, place the parts
in the upper basket and ensure that none of
the parts can get stuck. Otherwise they might
deform.
Storage
■ Store the cleaned appliance in a clean, dust-free
and dry location.
To Next Page
Loading...
Need help?
General
