EasyManuals Logo

Silvercrest SSR 3000 A1 User Manual

Silvercrest SSR 3000 A1
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11 GB/IE/NI
suitable protective gloves at all
times if such an event occurs.
In the event of a leakage of bat-
teries / rechargeable batteries,
immediately remove them from
the product to prevent damage.
Only use the same type of bat-
teries / rechargeable batteries.
Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
C
lean the contacts on the battery /
rechargeable battery and in the
battery compartment before in-
serting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Robot vacuum cleaner only
This product has a built-in lithium-
ion rechargeable battery which
cannot be replaced by the user.
The rechargeable battery must be
removed or replaced by the manuf-
acturer or their service centre or a
similarly qualified person to avoid
hazards. When disposing of the
product, you must indicate this
product contains a rechargeable
battery.
Set-up
Charging the product
Fully charge the product before using it for the first
time. It takes approx. 3 to 5 hours to charge. The
charging process is also indicated in the display
1
.
Set up the charging dock
2
and connect the
mains lead
4
.
Place the charging dock
2
flush against a wall.
Note: Keep 1 m from the left / right and 2 m
from the front clear.
Place the product in the charging dock
2
and
align it with the charging contacts
3
.
Note: The product automatically returns to the
charging dock
2
when the battery is low.
You can alternatively directly connect the
mains lead
4
to the charging socket
8
on
the product.
Switching the product on / off
Press the power switch
9
on the side of the
product. „I“ indicates switched on, „O“ indi-
cates switched off. If the display
1
lights up,
the product was switched on successfully.
Note: Do not switch off the product after it has
finished cleaning. Leave it in the charging dock
2
so that it is ready for the next cleaning session.

Other manuals for Silvercrest SSR 3000 A1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SSR 3000 A1 and is the answer not in the manual?

Silvercrest SSR 3000 A1 Specifications

General IconGeneral
BrandSilvercrest
ModelSSR 3000 A1
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals