Silvercrest SSRM 10 A1 User Manual

SilverCrest SSRM 10 A1
14 - English
First use
Setting the time
If a timer has already been programmed and is
active, the time cannot be set.
If no button is pressed for approx. 5 seconds, the
scan radio exits the setting mode. All previously
made settings are saved.
Press the "MODE" button (3) when the device is switched off. The
display (1) indicates the current hour format: "12HR" or "24HR".
Set your desired hour format by pressing the "-" button (2) or "+"
button (4). Press the "MODE" button (3) again. The hour display
flashes and you can then set it by pressing the "-" button (2) or
"+" button (4). Then press the "MODE" button (3) again. The
minute display then flashes and you can set it by pressing the "-"
button (2) or "+" button (4).
You can also keep the "-" button (2) or "+" button (4)
pressed to fast forward or reverse the numbers.
Finally, press the "MODE" button (3) again. The set time is now
indicated on the display (1).
If you have selected the 12-hour format, the hours before noon
(AM) or hours after noon (PM) are indicated on the display (1).

Silvercrest SSRM 10 A1 Specifications

General

Brand	Silvercrest
Model	SSRM 10 A1
Category	Radio
Language	English