Silvercrest STKK 16 B1 - Mounting the transmitter

STKK 16 B1
■ 16
│
GB
│
IE
│
NI
Mounting the transmitter
NOTE
► You will need a Phillips screwdriver and a drill
with a 5 mm drill bit to mount the transmitter.
► Only use the screwst and wall plugs r
provided to mount the transmitter.
► Ensure that there are no electric lines, water or
heating pipes installed at the proposed drilling
location!
► The supplied wall plugsr are only suitable for
mounting in concrete or stone. Before starting
the installation, please check your installation
location carefully for its suitability for the wall
plugs r . The assembly material must be suita-
ble for the respective location.
If in doubt, consult a professional.
► Alternatively, you can mount the transmitter
using the double-sided adhesive tape w onto a
suitable surface (maximum height 2 m).
♦ Select a suitable positioning for the transmitter,
close to your outer door.
IB_373415_STKK16B1_LB6_GB-IE-NI.indb 16IB_373415_STKK16B1_LB6_GB-IE-NI.indb 16 13.09.2021 13:38:1513.09.2021 13:38:15