Silvercrest STKK 16 B1 - Page 20

STKK 16 B1
GB
│
IE
│
NI
│
17 ■
♦ Remove the wall bracket0 from the rear side
of the transmitter by sliding it in the direction of
the open lock symbol
(see fig. 1).
Fig. 1
♦ Mark the positions for the two required drill
holes by holding the wall bracket0 against the
wall at the desired mounting location
(maximum
height 2 m) . Then mark the drill holes with the
two fixing eyeletsq.
♦ Use a drill with a 5 mm drill bit to drill the two
holes for the supplied wall plugsr.
♦ Insert the wall plugsr into the drill holes.
♦ Screw the wall bracket0 onto wall at the
desired mounting location using the screwdriver
and the
supplied screwst .
IB_373415_STKK16B1_LB6_GB-IE-NI.indb 17IB_373415_STKK16B1_LB6_GB-IE-NI.indb 17 13.09.2021 13:38:1513.09.2021 13:38:15