13
GB
• To switch off both earphones
1
/
6
outside the charging
box
12
, press and hold one of the multifunction buttons
2
/
5
for approx. 5 seconds until an acoustic signal is heard.
7.2 Connecting the earphones to the audio
device
The two earphones1/6 are connected to each other and to the
audio device via Bluetooth. TWS (True Wireless Stereo) enables
stereo playback without a cable connection.
NOTES:
• In order for the TWS connection to be established between
the two earphones, the left earphone1 must not be already
connected to the audio device (or another Bluetooth device
nearby) beforehand.
• If you encounter problems establishing the connection, pro-
ceed as described in the section “No connection to the
audio device” on page 14.
• The connection to the audio device is established with the
right earphone6.
• Please note that the establishment of the connection may
vary slightly depending on the device and the software
used.
1. Remove the earphones1/6 from the charging box12.
These are automatically switched on and connected to
each other via TWS. Then the LED4 of the right earphone
starts flashing red/white while the connection to the audio
device is being established. The earphone now transmits
the identification. The LED of the left earphone flashes
white.
2. Place the left earphone1 in your left ear, the right ear-
phone6
in your right ear.
3. If necessary, start the Bluetooth connection on the audio
device (e.g. smartphone, MP3 player). The audio device
should now receive the device identifier STWSK 3 A1.
__354190_2010_B6.book Seite 13 Montag, 17. Mai 2021 12:53 12
To Next Page
Loading...
Need help?
General
