Silvercrest SWEW 750 B3 - Extracting the removable plate; Commissioning

■ 26
│
GB
│
IE
SWEW 750 B3
Extracting the removable plate
1) Upper removable plate: Slide the locking devices  upwards and simul-
taneously tilt the removable plate forward so that you can lift it out from
underneath the lower mountings .
2) Lower removable plate: Pull the locking devices  forward and lift the
removable plate so that you can pull it out from the rear mountings .
Commissioning
Carry out the following procedure with each of the 3 pairs of removable plates.
■ Smear the non-stick coating on the removable plates with oil suitable for cooking.
WARNING! RISK OF INJURY!
► Let the appliance cool down before exchanging the removable plates!
Risk of Burns!
■ Install a pair of removable plates into the appliance.
■ Insert the plug into a mains power socket.
■ Close the appliance and lock it with the lid locking device .
■ Let the appliance heat up for about 10 minutes.
NOTICE
► With the first usage a slight smell can arise (minimal smoke development is
also possible). This is normal and dissipates after a short time. Provide for
sufficient ventilation. For example, open a window.
■ Disconnect the plug and allow the appliance to cool down.
■ Clean the removable plates and the appliance as described in the chapter
“Cleaning”.
The appliance is now ready for use.