Silvercrest SWR 300 A1 - Wireless Repeater Mode Setup

SilverCrest SWR 300 A1
64 - English
Configuring Wireless Repeater Mode
Wireless Repeater Mode is used to extend the range of your wireless network. Set up Wireless
Repeater Mode as follows:
 Plug the wireless repeater into a suitable power socket.
 Connect a network cable to the LAN socket (6) of the wireless repeater. Insert the other end of
the network cable into a free LAN socket on your computer.

Click on Wizard on the Home
page of the wireless repeater's
configuration menu and select
Wireless Repeater Mode.
Then click on Next.
 A window with all available
wireless networks will then open.
Select the network whose range
you wish to extend in the
Select
column and enter the password of
the selected network in the Key
column. Then click on Next.
 Click on Next in the new window.